The Elan Test Drive
Monday October 5 was my last kayak outing of the 2026 season. The lake level is currently being drawn down, eventually by 11+ feet for the cooler months, as is usual, I paddled from 3rd Avenue pier, under the highway and railroad bridges, and then up Sand Creek - my most frequent route.
I had a mission. I was trying out a kayak I just inherited from a dear friend, the Elan model from Mariner Kayaks. I had written in an earlier post (July 18 of this year) how my Boreal Designs Ellesmere kayak was my favourite kayak at that point - and I have tried many kayaks over the last ~20 years. So this mission was to determine whether I liked the Elan better than the Ellesmere.
I had actually tried this kayak when my friend first purchased it. The fit was too small, so I did not explore any further. However, once I inherited the kayak I investigated further. There are no foot pegs so one's feet rest against the front bulkhead. I discovered that the bulkhead had several layers of padding to adjust the fit. Upon removing the pads, the cockpit fit perfectly!
Mariner Kayaks produced a series of what have become cult favourites (e.g. their Coaster model). Only 76 Elans were built and Mariner ceased operating not too long afterward (~2007). This particular Elan had a rear watertight hatch, but originally no bow hatch. However, Victoria's John Abercrombie added a bow hatch before selling it. John builds or modifies kayaks and does splendid work. The Elan was built for a small person. I made the aforementioned modifications to the cockpit so I could fit comfortably, considering my brawny 140 pound, five foot five inch frame (and relatively large feet).
Despite having no rudder and no skeg, the Elan neither weathercocks nor leecocks at wind speeds beyond which I do not venture. It weighs 51 pounds (heavier than my kevlar Ellesmere - but quite manageable). If the Elan handles as well as the Ellesmere, it could become my new favourite. I like that idea - no fussing with a skeg (or rudder), no constraints on foot position dictated by foot pegs. Note that skegs, rudders, and foot pegs (extra frippery for me) can need repair - done that, been there.
All the Mariner kayaks were swede form i.e. widest beam aft of the boat's center. Swede form kayaks typically have a longer bow than stern section. This is quite emphasized in the Elan. From the front of the cockpit to the bow is 96" and from the back of the cockpit to the stern is 62"! I've had a mix of fish form and swede form kayaks over the last 20 years, but the Elan is the most extreme swede form I've had - and I like its performance and looks.
So, how did the test go? The water was flat calm and remained that way, perhaps not ideal testing conditions. The kayak behaved well, going in the chosen direction yet turning when desired, but there was no way to judge weathercocking in these calm conditions. However, the prior owner verified that the Elan did not weathercock. I loved having neither skeg nor rudder. For my paddling effort, the speed was much the same as for the Ellesmere. So the jury is out until next spring, but I am now predisposed to declare the Elan as my new (and final) favourite.


0 Comments:
Post a Comment
<< Home